Tuesday, April 29, 2008

Experiment #5 [[Force and Acceleration]]

Experiment: Force and Acceleration

Objective: To prove that by increasing the force on an object the acceleration of the object increases also.

Hypothesis: As the washers are added to the paper clip it gradually weighs down the cart and the cart is gradually pulled towards the washers. When more washers are added the speed of the cart increases.

Procedure: 1. Tape the steel rod to the edge of a table so that it s directly over the edge. This will act to reduce friction in the experiment.
2. Cut a piece of string 1 meter long. Attach one end of the string to the Hall’s cart using a paper clip.
3. Open up a paper clip to form a loop on one end and a hook on the other. Tie the loop end of the paperclip to the free end of the string.
4. Put the cart on the table about ¾ of a meter from the rod and hang the end of the paperclip over the rod.
5. Add washers to the paperclip hook one at a time until the cart begins to move (it should take 1-3 washers). Carefully observe the speed of the cart as it moves along the table. Repeat 4-5 times and record the number of washers used each time.
6. Think about doubling or tripling on the cart by doubling or tripling the number of washers. Write your prediction down as a hypothesis.
7. Repeat step 5, but this time double the force by doubling the number of washers. Observe the speed and acceleration of the cart carefully. Repeat several times. Record your results.
8. Repeat step 7, but this time triple the number of washers used in step 5. Observe the speed and acceleration of the cart carefully. Repeat several times. Record your results.

Data:
Trial 1- Number of washers used: 3
Results: The cart moved a little distance at a slow speed.

Trial 2- Number of washers used: 4
Results: The cart moved a bit faster and traveled a greater distance.

Trial 3- Number of washers used: 5
Results: The cart moved faster and traveled a greater distance.

Trial 4- Number of washers used: 6
Results: The cart’s speed and distance greatly increased.

Trial 5- Number of washers used: 7
Results: The cart’s speed and distance steadily increased.

Graphs/Pictures:

Photobucket

Conclusion:After completing this experiment there is an array of things I can say that I have learned and have realized are applicable to the world in which we live in. When adding the washers to the end of the paperclip, I realized that the force the washers had applied in pulling the cart was gravity itself. To answer the question of this experiment, yes, it takes more force to accelerate the cart quickly rather than slowly; the reason being that more washers were needed to keep the cart moving at a fast and steady pace rather than just a slow one. In fact my hypothesis was correct, the more force the washers created, the faster the cart traveled. From this I can say that in actual life when enough force is exerted on an object the object will in fact travel at a fast and steady distance until that force is removed. As stated in Newton’s law the force required to accelerate the cart is proportional to the rate of acceleration. While performing this experiment my colleagues and I had difficulty putting as large amount of washers on the paperclip, for it is only but so wide, but I still learned that gravity is a universal force that pushes and pulls everything on the earth’s surface.

Friday, April 18, 2008

Experiment #4 [[ Force to Change Speed or Direction of a Moving Object]]

Experiment: Force to Change Speed or Direction of a Moving Object

Objective: To prove that that force needed to change the speed and direction of a moving object is a factor in the speed need to maintain the initial speed of the object.

Hypothesis: The force to keep the initial speed of the cart will be greater than the force required to maintain the initial speed of the cart. Once the cart changes its direction the force required to maintain the initial speed of the car will be lesser.

Procedure: 1. Use the same setup as experiment 2 with the 200g mass, string, and spring scale.
2. Start moving at a slow speed by pulling on the spring scale. Then quickly pull harder to accelerate the speed of the cart. Repeat this several times while reading the spring scale. Record the maximum force reading on the scale each time.
3. Experiment with changing the direction of the cart. Start the cart rolling slowly by pulling on the spring scale and then pull the scale in a wide arc to change the direction of the cart. Try this several times, changing direction as quickly as you can without tipping the cart over. Record the maximum force to change the direction each time.
4. Analyze Results. Begin to draw conclusions.

Data:
Accelerating the Cart
1. 0N-1.N
2. 0N-1.5N
3. 0N-1N
4. 0N-1.5N

Changing the Direction
1. .5N-2N
2. .5N- 4N
3. .5N-2N
4. .5N-3N

Graphs [[Pictures]]

Photobucket

Conclusion:
After completing this experiment I have concluded that my hypothesis was partially incorrect. It required more force to maintain the initial speed of the cart when changing the speed and the direction. The force required to change the speed or direction of a moving object is consistent with Newton’s first law, all objects in motion will remain in motion. Though I had difficulty understanding the experiment I don’t think anything went wrong during this experiment. I learned that when your changing direction you actually accelerating at a faster pace. In actual life when one is running and makes a sharp turn they are still running at a fast pace but in a different direction.

Experiment #3 [[Objects in Motion Remain in Motion]]

Experiment: Objects in motion remain in motion.
Objective: To prove that objects in motion continue to be in motion unless acted upon an external force.

Hypothesis: Once the cart collides with the edge of the ramp the 100g mass is going to roll off the cardboard.

Procedure: 1. Place the wooden ramp on the floor.
2. Tape a piece of cardboard over the hole in the Hall’s cart.
3. Put the 100g mass on top of the cardboard.
4. Gently push the cart so that it collides with the edge of the ramp. You must push the cart gently enough so that the mass does not move until the cart hits the ramp. Repeat 4-5 times.
5. Analyze results. Draw conclusion.

Data:
Trial 1- The 100g mass falls on the floor.
Trial 2- The 100g mass rolls onto the board,
Trial 3- The 100g mass falls on the floor.
Trial 4- The 100g mass rolls on to the floor.
Trial 5- The 100g mass rolls on the board.

Graphs [[Pictures]]

Photobucket

Conclusion: After performing this experiment and seeing first hand that the 100g mass fell during every trial, I am convinced that when influenced by an external force an object in motion remains in motion. The 100g mass was in motion while it was on top of the cart and remained in motion when it fell of the floor. Taking a look at Newton’s first law of motion and after witnessing this experiment, his law is absolutely true. My hypothesis was proven to be correct once the cart came in contact with the board the 100g mass did roll of the cardboard every time. Though this lab ran smoothly with no errors, I believe that it would have been more accurate if there were more trials done and the cart we used was bigger. I learned that an object in motion really remains in motion without any discrepancies. In real life, when someone is running at a fast pace it takes time for them to stop unless they impact a force. The same lesson that was learned by doing this experiment can be applied to forms of movement made everyday.

Thesis Statements

Topic Quesion: What are the factors that hinder the enrollment of African American males in higher education?

Thesis Statements: 1. When taking a look at the African American comminity it becomes quite evident that the factors that may hinder the enrolment of an African American male in higher eduation may be family, finances, or their lack of determination/perserverance.

2. I believe that the factors that hinder African American males from enroling in higher edcation primarily envolve their family backgrounds.

3. The hindrance that is placed on African American males which prevent them from enrolling into higher education mainy is visable because of their living situations.

Friday, April 11, 2008

Physics Experiment #2 [[Force to move objects from Rest]]

Experiment: Force to Move objects from Rest.


Objective- To prove that the force required to move an object from rest is not different than the force required to keep the object moving.


Hypothesis- The force required to move an object from rest has to be greater than the force required to keep the cart moving in order to really push the cart.


Procedure- 1. Cut a piece of string about 8” long. Tie one end to the front of the Hall’s cart and tie a loop in the free end.
2. Put the 200 gram (g) mass in the Hall’s cart.
3. Push the cart back and forth on the table and think about the problem statement. Write down your hypothesis before you continue.
4. Zero the spring scale and attach the hook on the spring scale to the string on the loop on the cart.
5. Tug on the spring scale several times to start the cart moving from rest. Note and record the spring scale reading every time.
6. Now jerk on the spring scale several times to rapidly start the cart moving from rest. Note and record the spring scale reading every time.
7. Finally, pull the cart across a table or floor at a constant speed several times. Note and record the readings each time. Try this step again, pulling the cart at a faster speed. Note and record the spring scale reading every time.
8. Analyze Results.


Data-
When Tugged: Trial 1 - .5n (50 g) Trial 2- 1n (100g) Trial 3- .5n (50g)

When Jerked:Trial 1- .5n (50g) Trial 2- 1n (100g) Trial 3- 1n (100g)

When at a Constant speed:Trial 1- .5n (50g) Trial 2- .8n (80g) Trial 3- .5n (50g)

When at a faster Speed:Trial 1- 1.5n (150g) Trial 2- 1n (100g) Trial 3- 1.5n (150g)

Graphs/Pictures-

Photobucket


Conclusion- After performing this experiment I can now say that it takes more force to keep an object moving than just to get it to move. I also know that it takes more force to start an object moving quickly than it does to move an object slowly. My hypothesis was correct. I said that it takes more force to keep an object moving, which it does. I can say that this does follow Newton’s first law for a body at rest, because the cart moved when an external force was exerted upon it. Though nothing went wrong I learned that force is force, in many instances during the experiment the cart experienced the same level when jerked and when lightly pushed. When you think about it this experiment applied to everyday life. Just like when you kick a ball. Sometimes no matter how hard you kick it, it’s going to roll.

Physics Experiment #1 [[Objects remain at rest]]

Experiment: Objects at rest remain at rest.

Objective- To prove that objects at rest really remain at rest unless acted upon by external forces.

Hypothesis- If the ramp is pulled from underneath that cart, the cart will roll onto the table and continue to roll.

Procedure- 1. Set the wooden ramp on a table with about 12” of the ramp extending over the edge of the tables.

2. Place the Hall’s cart on top of the part of the ramp that is on the table. The cart is not at a state of rest. Write down hypothesis.

3. Standing to one side, quickly jerk the ramp out from underneath the Hall’s cart. Try this 4-5 times. Record your results.

4. Analyze results and conclusion.

Data- Trial 1- The cart rolled off the table but didn’t move. Trial 2- The cart rolled off the table but didn’t move.

Trial 3- The cart rolled off the table but didn’t move.

Trial 4- The cart rolled off the table but didn’t move.

Graphs-
Photobucket

Conclusion- In the end when the ramp was removed from underneath the cart, the cart was released onto the table but did not move. My hypothesis was semi-correct. The cart was released onto the table, however, it did not move once on the table like I had anticipated. Newton’s 1st law was proved by this experiment to be correct because the cart remained at rest it was just at rest on a different surface. Through all five trials we encountered the same results. Though nothing went wrong, I learned that Newton’s 1st law is actually evident in real life. It would be the same in an actual situation. Just like if you had an actual vehicle and moved it off a tow truck it can’t go anywhere without actual force exerted on it.